If you’re a homeowner and have had to call a plumber to fix a problem, you know how expensive and annoying it can be. Wouldn’t it be great if you could fix your plumbing yourself? Well, it might be easier than you think! Read on to find out how.

Before starting any plumbing project be sure to turn off the main water supply. Water damage can be one of the most expensive things to repair. To minimize damage turn the main water supply off as well as any shut off valves near where you are working. This will save a great deal of hardship later on.

Use the sounds you hear from your pipes to help you to determine what they problem is. Certain sounds mean the water pressure is too high. Other sounds can signify loose pipes or slight clogs from calcium or iron build up. Listening to your pipes can save you a lot of money hunting down the problem.

Act quickly if your pipes freeze! Shut off the water and open the faucet, enabling it to drain when it thaws. Starting with the faucet, and working your way to the iced-up area, aim a propane torch or hairdryer at the pipe – this will quickly defrost it. You could also wrap the pipe in a heating pad or aim a heat lamp at it, but this will take quite some time. A last resort is to wrap the pipe in rags and pour boiling water over it.

To prevent the pipes from freezing, it is advisable to seal off air vents, cracks and access doors. In order to keep the heat in and the cold out, you can try using insulation or caulk. In the event a leak occurs, make it a point to remind everyone where the master circuit breaker is so it can be shut off immediately.

If you have issues with the plumbing making a hammering sound when you turn it off, check your water pressure. Any time your water pressure is above 80 PSI, you will hear extra water noise. This can be easily solved by the installation of a pressure-reducing valve, which can be done by most homeowners.

Check how well your toilets are flushing. If the handle needs to be played with in order to keep the water from running constantly, or if it needs to be held down several times in order to flush, you may need to switch out some of the parts in your tank. This is not expensive, and it could help reduce your monthly water bill. It could also mean that you avoid the embarrassment of the flushing system breaking when you have visitors!

If your sink is letting rusty water out and it will not drain, it is mostly likely because of the biological scum and grease that is built up in the pipes. You need to have your drains professionally cleaned, allowing maximum flow through your drains. Your drains must be open completely.

It is not always necessary to call in a plumber when you have a damaged section of pipe in your plumbing. There are repair kits you can buy in your local hardware store which are excellent in repairing leaks. If you have a small leak, you can rub a compound stick over the hole or crack in the pipe to seal it shut. Epoxy paste is also an excellent remedy for a leaking pipes. Make sure you turn off the water and completely dry the pipe before applying the epoxy.

Watch how your toilets are flushing. If you have to jiggle the handle or if it takes too long, you might have to repair some toilet parts. Replacing these parts early may help you to save on your water bills and will save you from more expensive repairs at a later date.

Avoid pouring grease or oil down your kitchen sink drain. Grease and oil can build up in your pipes and cause a backup. Instead, wait for the grease or oil to cool and solidify and either throw it away or see if there’s a place to recycle it near your home.

When you’re going away on a vacation, you should consider shutting off the water supply to your home. This can help stop many problems before they start. If you don’t do this, you should have someone stop by your house regularly to check that nothing has gone wrong and that your home isn’t flooded.

To prevent pipe banging when you turn on the water, think about rubber blankets or straps. Instead of assuming the pipes need replaced, consider anchoring them or buffering them. If your pipes are plastic, leave them some room for expansion and contraction. If pipes do not leak but just make noise, eliminate the noise.

As you can see, solving your plumbing problems yourself can be a satisfying way to save money and take care of your house independently. Next time you have a plumbing problem, you’ll be ready to tackle the issue yourself with the tips you’ve taken from this article.