If you have to fix the plumbing in your home, you may be overwhelmed about what to do and where to begin. These tips will help you accomplish the unthinkable and establish control over your plumbing once again!

On very cold winter nights, allow your faucets to trickle slightly, especially if your pipes are located in a crawlspace. The running water prevents the pipes from freezing as quickly as they would otherwise. You can catch the water and use it for other household needs to prevent wasting it.

Act quickly if your pipes freeze! Shut off the water and open the faucet, enabling it to drain when it thaws. Starting with the faucet, and working your way to the iced-up area, aim a propane torch or hairdryer at the pipe – this will quickly defrost it. You could also wrap the pipe in a heating pad or aim a heat lamp at it, but this will take quite some time. The last resort is to wrap the pipe in rags and pour boiling water over it.

Don’t be afraid to call a professional. Don’t take on jobs to save money, if you aren’t sure how to fix them. Calling a professional plumber saves you money, the experience and know-how can fix your problem sooner and with less fuss.

Roots from a tree in your backyard can be a real headache when it comes to plumbing. Make sure if you have a big tree or bush or some kind of plant with a big root system, that you ask your plumbing company about root-killing agents. You can flush these down your toilet and kill any roots that may be blocking your pipes and save yourself a lot of money by stopping a backup before it happens.

Use a hairdryer to thaw frozen pipes, after you shut off the water to the house. A hairdryer will gently heat the pipe and thaw the ice without causing significant damage to the pipe. Shutting off the water first means that if the pipe is broken, there will be no rush of water into the house.

Avoid using hard cleaners on your toilets, such as drop-in cleaner tabs in the tank. When these tabs are almost completely dissolved, what’s left of the tab gets washed into the bowl. This can then end up clogging the toilet’s port holes, preventing the toilet from flushing properly. It can take months for this debris to finish dissolving in those holes.

Have you tried patching your pipe with the store-bought patching kits only to have that section of your plumbing continue leaking? Replacing the damaged pipe is a more permanent solution than patching. First, you must shut off the main water valve, and drain the water from the damaged section. Cut out the damaged section of the copper pipe, leaving about an inch of extra pipe on both sides of the damaged area. Remove corrosion from inside the pipes with a wire brush. Apply flux to the replacement pipe and the remaining pipe. Slide the piece of replacement pipe into place with couplings. Apply solder all around the joint, and use a propane torch to solder the replacement section into place.

Do not overload your garbage disposal. If you need to dispose of large items, cut them up into smaller pieces. Also, do not put too much in at a time, but one or two items in and wait a few seconds to dispose of the rest. Overloading your disposal can cause the engine to overheat.

Set the temperature on your hot water heater to a temperature that does not exceed 120 degrees. This helps to save energy and prevents the water from becoming too hot and potentially scalding someone in your household. Older models that do not have a temperature setting should be set on Medium.

One of the things that you can do to maximize the security of your home is to seal all of the cracks in your outdoor faucets. Even a tiny crack can intensify as the season progresses and lead to serious problems down the road. Reduce drips and leaks for optimal protection.

In conclusion, plumbing is actually quite straightforward. There are just certain aspects of plumbing a person needs to know. All that is needed to start is common sense, effort and research to determine the most efficient way of handling your particular job.