Good plumbing maintenance is relatively easy, but failing to keep up with it can mean costly repairs. Here are some good ways you can take care of your plumbing, either yourself or with the help of a licensed professional. Take care of your house now and it will benefit you in the future.

If you are paying someone else to do the plumbing in your home be sure that they are licensed in your state to do that work. Some people who have little or no knowledge of plumbing will try to pass themselves off as a pro. So you can see the importance of checking to see if your plumber is licensed. You should also see if you can find positive testimonials about the plumber’s work.

The next time you have a clogged drain, avoid the simple solution of dumping drain-clearing chemicals into the pipes. While this method involves the least amount of effort, the chemicals in these liquid cleaners are destructive to your piping. Instead, consider using a little bit of elbow grease with a plunger, snake, or other device designed to clear your clog without chemicals.

Don’t pay a plumber until the job is completed. A plumber may require some money upfront, but it’s wise to wait until the job is completely done before giving him the entire payment. Many things can happen between the stop and end of a job, so to be safe wait until you are satisfied with the completed work before paying.

If you have issues with the plumbing making a hammering sound when you turn it off, check your water pressure. Any time your water pressure is above 80 PSI, you will hear extra water noise. This can be easily solved by the installation of a pressure-reducing valve, which can be done by most homeowners.

Have you tried patching your pipe with the store-bought patching kits only to have that section of your plumbing continue leaking? Replacing the damaged pipe is a more permanent solution than patching. First, you must shut off the main water valve, and drain the water from the damaged section. Cut out the damaged section of the copper pipe, leaving about an inch of extra pipe on both sides of the damaged area. Remove corrosion from inside the pipes with a wire brush. Apply flux to the replacement pipe and the remaining pipe. Slide the piece of replacement pipe into place with couplings. Apply solder all around the joint, and use a propane torch to solder the replacement section into place.

Set the temperature on your hot water heater to a temperature that does not exceed 120 degrees. This helps to save energy and prevents the water from becoming too hot and potentially scalding someone in your household. Older models that do not have a temperature setting should be set on Medium.

Before embarking on a plumbing project, make sure that you’re aware of where the shutoff valve for water in your home is, as well as the valves for shutting off individual structures like sinks, toilets, etc. This way, if something goes wrong, you’ll be able to stop the water flow.

Stay away from drain cleaners! The chemicals in those kinds of drain cleaners can be corrosive and might damage pipes if you keep using them. Instead, if you find your drain is blocked up, look at hiring a professional to come out and look at it to see what the problem is.

Garbage disposals are a common cause of plumbing problems, which is an easy problem to solve. Don’t just put everything down at your disposal or treat it like a second trash can. Use the disposal things that would be difficult to dispose of normally. Putting all leftover food down the sink is a good way to produce clogs.

If you find that your pipes have frozen during the cold winter months open all the faucets in your home. This lowers the water pressure for when the pipes thaw and the water is freely flowing again. Make sure to open all the faucets not just those that are frequently used.

As mentioned above, most periodic plumbing maintenance is simple and straightforward. Most repairs resulting from serious damage to your plumbing are not. Now that you know how to deal with the plumbing issues in your home, you should be more prepared to prevent or mitigate the more serious problems that can result.