Rigid copper is used for main water lines in many homes. You cannot bend rigid copper, so joints and tees must be soldered on. When soldering, always apply flux (also called soldering paste) to both surfaces. Flux retards oxidation when the copper is heated. Always use lead-free or nearly lead-free solder when sweating a copper joint.

To avoid clogs, pay attention to what you flush. Sanitary napkins, thick toilet paper and baby wipes should never be flushed. These items can expand and cause a clog, or get caught on a pipe. Instead, dispose of them in a sanitary way that does not involve flushing them down the toilet.

If your pipes are prone to freezing, let the water trickle continuously in at least one faucet during weather that is below freezing. This will minimize the chances that the pipes will freeze and leave you without water. If water is continually running through the pipes and trickling out of a faucet, the pipes are less likely to freeze.

Use your garbage disposal with the cold water running so that you can preserve the blades of the disposal. Using hot water makes grease more liquid and can cause problems, including clogs. Make sure to clean blades by putting in a little dish detergent and running cold water at the same time.

If you have bad water pressure in the shower, the showerhead might be clogged. Take a plastic baggie, fill it with regular vinegar, and tie it to the showerhead so that the showerhead is covered. Leave it overnight. In the morning, take the baggie off and use a small toothbrush to scrub away any mineral deposits.

Make sure you clean out overflow holes in your kitchen and bathroom sinks on a regular basis. These holes are intended to act as an emergency fail-safe to prevent spillage from a full sink, but if they are clogged they can’t do their job. You can clean out an overflow hole using the same techniques you would for a clogged drain.

You can check for damage to the floors around the toilets by checking for soft areas. Stand above the toilet with a foot positioned on each side up close to the base. Shift your weight back and forth to detect any weakness or sponginess. Discovering this issue sooner can mean big savings for your checking account, as compared to finding out about it later.

Swapping out old shower heads for energy-efficient ones can save you money on the energy bill. Most of the hot water we use is used while we are showering. A single energy-efficient shower head can save you $100 a year.

One of the things that you can do to safeguard your home from any serious plumbing issues is to install a flood alarm. This is a device that will sound when it comes in contact with water, alerting you if there are any issues in a particular area in the house.

During the warm seasons, you will see that there will be many bird nests forming in and around your plumbing vent pipes. It is essential to clear these out, as they can have a devastating effect on the quality of your plumbing and the flow of water in your home.

To make sure there is no accident or sudden rush of water when you tackle a plumbing project, make sure you are ready for a cleanup. If you go into the work with a huge stack of towels and blankets ready to absorb water, the prospect of needing to actually do it will keep you alert enough to avoid triggering the accident in the first place.

As you can see, hiring a professional plumber is usually an unnecessary and expensive thing to do, compared to fixing the problem yourself. Next time your plumbing needs repair, try pulling up this article and trying to solve it yourself. You may be surprised how easy it is to do!