Good plumbing maintenance is relatively easy, but failing to keep up with it can mean costly repairs. Here are some good ways you can take care of your plumbing, either yourself or with the help of a licensed professional. Take care of your house now and it will beneift you in the future.

Find a plumber that you can trust. Make sure to get referrals from friends and family so that you can prevent getting ripped off, which happens often. Also make sure not to pay the plumber before the work is completed. If you do that, there will not be an incentive to get the job completed in a timely manner.

Make sure you know where your home’s water shutoff is located. You never know when there might be an emergency involving a broken pipe or damaged connection that requires you to turn off the water right away. In addition, knowing where the shutoff is located is vital before you start any plumbing project, in case anything goes wrong.

Ensure that everyone in your household knows how to turn off the main water supply, or knows how to contact someone who can. In the event of a burst pipe or other water-related emergency, you should immediately turn off the water to prevent flooding, structural damage, and a sky-high water bill.

The next time you have a clogged drain, avoid the simple solution of dumping drain-clearing chemicals into the pipes. While this method involves the least amount of effort, the chemicals in these liquid cleaners are destructive to your piping. Instead, consider using a little bit of elbow grease with a plunger, snake, or other device designed to clear your clog without chemicals.

Have your septic tank cleaned every five years to keep it in prime condition. This keeps the tank from developing a buildup of sediment, thereby preventing the septic system from backing up or failing altogether as a result. While it may cost a bit to have your septic tank pumped out, it will cost you much more to clean up any sewage backup or to repair or replace your septic tank.

If you have a clogged toilet with the water level very low, and plunging it isn’t working, it’s possible to resolve this by pouring warm water from a bucket directly into the toilet bowl from about waist level. Once the water level is low again, you may repeated this procedure.

Check your gas water heater periodically to make sure the pilot flame is lit. The correct color for this flame should be blue. The tip of the flame should be yellow. If you find that you are only seeing a yellow flame, you may need to call a professional for safety reasons.

Look at the overflow holes to ensure they aren’t clogged up. If your sink starts to overflow, the water will run into the overflow holes, this might not be a huge issue, unless they are clogged. Clear overflow holes when doing periodic checks for problems and plumbing issues that should be addressed.

Don’t start any do-it-yourself plumbing project without having a plan in place. You need to know beforehand exactly what you are getting yourself into. Know what kind of space you are working with and what lines are which. Getting a clear picture early on will make your plumbing project go a lot smoother!

Before you can fix a toilet that does not flush properly, it is important that you find out what is causing the problem. Depending on what the problem is, you may be able to fix it yourself. However, more complicated toilet flushing problems may require the services of a plumber.

The most important plumbing tip you need to know is — how to turn off your home’s main water supply. Once the water is shut off, you can investigate problems and figure out how to resolve them. Walk the family through the house and show them where all the water shut-off valves are, and how to use them.

To prevent pipe banging when you turn on the water, think about rubber blankets or straps. Instead of assuming the pipes need replaced, consider anchoring them or buffering them. If your pipes are plastic, leave them some room for expansion and contraction. If pipes do not leak but just make noise, eliminate the noise.

Valves that are used only infrequently sometimes fuse together. You can prevent them from becoming fused by regularly maintaining them with a penetrating oil, and running water through them on a regular basis.

As mentioned above, most periodic plumbing maintenance is simple and straightforward. Most repairs resulting from serious damage to your plumbing are not. Now that you know how to deal with the plubming issues in your home, you should be more prepared to prevent or mitigate the more serious problems that can result.